Cover And Cushion, Removing And Installing, Bench Seat: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Engage the rear molding into the seat frame first, and then pull the cover tight.
-- Flip the protective strip -1- over 180° toward the inside in direction of -arrow A-.
-- Engage the protective strip in the groove on the molded part in direction of -arrow B-.