Inner Mounting Pin, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the backrest from the center bearing. Refer to CENTER BRACKET, REMOVING AND INSTALLING .

-- Remove the chafe protection -4- and then remove the mounting pin -3- from the backrest frame -1-.

Fig 1: Exploded View Of Inner Mounting Pin

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bearing sleeve -2- from the mounting pin.

NOTE:

For clarity, the cushion and cover are not shown.