Seat Angle Adjuster, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seat into its highest position.

-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .

Standard/Sport Seat/Super Sport Seat:

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damage to the bushing in the bearing point (adjusting spindle/seat pan threaded connection -1-).

The bushing cannot be replaced with workshop materials.
If the bushing is damaged, the corresponding assembly parts must be replaced.

-- Remove the bolt -1- for the seat angle adjustment motor adjusting spindle.

-- Disconnect the connector -2- from the seat angle adjustment motor.

-- Remove the bolts -4- and remove the seat angle adjuster motor -3-.

Standard Seat, China Version:

Fig 1: Disconnect Electrical Harness Connector On Seat Angle Adjustment Motor

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging the bushing in the bearing point (adjusting spindle/seat pan threaded connection -2-).

The bushing cannot be replaced with workshop materials.
If the bushing is damaged, the corresponding assembly parts must be replaced.

-- Disconnect the connector -3- at the seat angle adjustment motor.

-- Remove the bolts -1- and the seat angle adjustment motor -4-.