Backrest Cover, Removing And Installing, Standard Seat, China Version: Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Upper Backrest Crossmember -1-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

-- Insert the backrest cover with the upper hooks -2- into the backrest frame -1-.

-- Pivot the backrest cover downward and engage the side tabs -3 and 5- and the lower hooks -4-.

-- Make sure the tabs on the side fit correctly into the backrest frame and the lower hooks are bent correctly over the backrest frame.

-- Push forcefully on the backrest cover on the areas marked with the -arrows- until the tabs and hooks click into place.

Fig 2: Backrest Cover

Courtesy of AUDI OF AMERICA, LLC

-- Check if the backrest cover is correctly latched.

It must not be possible to move the backrest cover at the bottom.