Overview - Seat Position Sensor
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The front passenger side is shown.
- Wiring Harness
- Seat position sensor/passenger occupant detection sensor/seat belt switch
- Clip into the seat frame
- Black connector, connector station in the vehicle floor under the seat
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Front Passenger Occupant Detection Sensor -G128-
- Only the front passenger side
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and installing. Refer to Front Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
- Push into the seat pan until they click into place
- Passenger Occupant Detection Sensor Bracket
- Clip into the seat frame
- Removing and installing. Refer to Front Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
- Connector Coupling
- For the Seat Belt Latch
- Seat Rail
- Tunnel-side
- Seat Position Sensor
- Driver Seat Position Sensor -G553-
- Front Passenger Seat Position Sensor -G554-
- There are different versions. Refer to the Parts Information for the allocation.
- Removing, installing and adjusting. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
- Checking. Refer to Vehicle Diagnostic Tester.
- Bolt
- 1.6 Nm