Overview - Front Three-Point Seat Belt
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Automatic Belt Retractor without Electric Seat Belt Tensioner
- Removing and installing. Refer to FRONT THREE-POINT SEAT BELT, REMOVING AND INSTALLING .
- Automatic Belt Retractor with Electric Seat Belt Tensioner
- Removing and installing. Refer to FRONT THREE-POINT SEAT BELT, REMOVING AND INSTALLING .
- The Left Front Seat Belt Tensioner Control Module -J854- / Right Front Seat Belt Tensioner Control Module -J855- must be adapted after replacing the automatic belt retractors using the Vehicle Diagnostic Tester.
- Seat Belt Height Adjuster
- Seat belt height adjuster must be replaced if the belt tensioner has deployed with the belt buckled
- Removing and installing. Refer to SEAT BELT HEIGHT ADJUSTER, REMOVING AND INSTALLING .
- Bolt
- 27 Nm
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.
- Seat Belt Guide
- Bolt
- 45 Nm
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.
- Front Seat Belt Guide
- Place seat belt webbing in the front seat belt guide
- Do not jam or damage the seat belt webbing
- Removing and installing. Refer to FRONT SEAT BELT GUIDE, REMOVING AND INSTALLING .
- Bolt
- 4 Nm
- Connector
- For the front seat belt tensioner control module
- Connector
- For the seat belt force limiter
- Connector
- For the seat belt tensioner igniter 1
- Belt End Fitting
- Engaged to the pins and pull upward until the spring tabs audibly engage
- Removing and installing. Refer to FRONT BELT END FITTING, REMOVING AND INSTALLING .
- Bolt
- 45 Nm
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.