Component Location Overview - Passenger Occupant Detection System
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The seat heating element is used for the passenger occupant detection system.
- Wiring Harness
- For the seat position sensor/seat belt fastening detection/seat belt switch
- Clip into the seat frame
- Black connector, connector station in the vehicle floor under the seat
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Wiring Harness
- For the seat heating element with passenger occupant detection system
- Clip into the seat frame
- Green connector, connector station in the vehicle floor under the seat
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Control Module Bracket
- Clip into the seat frame
- Passenger Occupant Detection System
- The seat heating element is used for the passenger occupant detection system.
- Depending on the seat version, the passenger occupant detection system is either sewn into the cover with the seat heating element, or bonded onto the seat cushion
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Nut
- 1.5 Nm
- Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to -Item ) OVERVIEW - SEAT POSITION SENSOR - List Item: Bolt