Overview - Fuel Tank, TFSI Vehicles With Fwd/AWD
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- Mounting Strap
- Secured to the fuel tank with expanding clips.
- Bolt
- 20 Nm
- Fuel Line
- To the engine
- Do not kink
- Clipped to the fuel tank
- Connector couplings, disconnecting and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Protective Plate
- For the fuel filler neck
- Rivet
- Quantity: 2
- Ground Connection
- For protective plate
- For discharging electrostatic charge. Refer to Fig 2.
- Cap
- Attached to the fuel filler door unit with fastener
- Turn until it clicks into place.
- Bolt
- 8 Nm
- Secures the fuel filler neck and works as the ground connection
- Quantity: 2
- Bleeder Line
- To the EVAP Canister
- Do not kink
- Connector couplings, disconnecting and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Mounting Strap
- Secured to the fuel tank with expanding clips.
- Bolt
- 20 Nm
- Bolt
- 20 Nm
- Fuel Tank
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and Installing. Refer to FUEL TANK, REMOVING, TFSI VEHICLES .
- Bushing
- Rubber Bushing
- Mounting Strap
- Secured to the fuel tank with expanding clips.
- Bolt
- 20 Nm
- Bolt
- 20 Nm
- Spring Nut
- 2 Nm
- For the heat shield
- Quantity: 5
- Heat Shield
- For the fuel tank
- Bolt
- 20 Nm
Ground Connection Routing
-- Route the ground connection as shown.
-- Make sure the following connectors are secure:
- The connector -arrow A- must be connected securely on the metal ring and the connector -arrow B- must be connected securely on the protective plate of the fuel filler neck.