Overview - EVAP System, Market-Specific Rest Of World

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The overview only applies to TFSI vehicles.

Fig 1: EVAP System, Market-Specific Rest Of World

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Quantity: 3
- 8 Nm
Nut
- Quantity: 2
- 20 Nm
EVAP Canister
- Component location: right rear
- Removing and Installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, MARKET-SPECIFIC REST OF WORLD .
Bleeder Line
- From the fuel tank
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Vent Line
- Vents out to the right rear under the wheel housing liner
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Bleeder Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Clipped to the underbody
Bracket
Bolt
- 20 Nm