Calibration Tool: VAS6350A, INSTALLING AND ALIGNING: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Unit: VAS6350A
- Calibration Tool - Wheel Center Mountings: VAS6350/1
- Calibration Tool - Spacing Laser: VAS6350/2
- Calibration Tool - Linear Laser: VAS6350/3A
- Vehicle Diagnostic Tester
After performing repair work on the vehicle, it may be necessary to re-calibrate the rearview camera system. Specifically, this is the case after:
- Rearview Camera -R189-, Removing and Installing
- Collision repairs on rear lid
- Changes to the axle alignment on the rear axle