Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove any CD/DVDs and SD/SIM cards from the Information Electronics Control Module 1 -J794-.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

The wires to the Information Electronics Control Module 1 -J794- are very short. For this reason the bracket must be removed first. With the removal of the glove compartment two bolts for the bracket are loosened.

-- Remove the bolts -arrows- and fold the bracket -1- downward.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors from the Information Electronics Control Module 1 -J794- -2-.

-- Insert the : VAS6223/9 -1- onto the MOST bus connector -2-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Insert the two clips from the : T10057 into the release slots on the Information Electronics Control Module 1 -J794-.

The points on the grip eyelets of the : T10057 face outward.
Both : T10057 must engage.

-- Remove the Information Electronics Control Module 1 -J794- from the bracket at the : T10057 grip eyes.

-- Press the release tabs on the Information Electronics Control Module 1 -J794- and remove the : T10057 .