Close Range Communication Control Module -J1169-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

NOTE:

In the illustration the storage compartment is shown without the center console.

-- Tilt the Close Range Communication Control Module -J1169- -1- with the bracket -3- out of the storage compartment -2-.

Courtesy of AUDI OF AMERICA, LLC

-- To do this, push the rubber lip on the bracket -3- using the : T40388 -A- carefully to the side and guide in the : T40388 as shown.

-- The catch on the bracket -3- is released and engages in the groove on the : T40388 -A-.

-- Remove the Close Range Communication Control Module -J1169- -1- and bracket -3- with the : T40388 -A- vertically upward out of the storage compartment.

-- Release and disconnect the connectors from the Close Range Communication Control Module -J1169-.

-- Press the catches -arrows- and remove the Close Range Communication Control Module -J1169- -1- from the bracket -3-.