Rear Pull Handle, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the door trim panel. Refer to REAR DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Place the door trim panel on a soft surface.
-- Disconnect the connectors at the rear of the door trim panel.
-- Remove the bolts -arrows- .
-- Remove the pull handle with the armrest -1- from the door trim panel.
-- Release the retainers -1- using a small screwdriver. At the same time, unclip the switch mount -2- from the pull handle -3- using the :T10383/1 in direction of -arrow- .
-- Release the remaining retainers and remove the switch mount.