Speaker Trim, Removing And Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Wedge Set:T10383

Center Speaker Trim, Removing:

Fig 1: Speaker Trim

-- Detach the speaker trim -1- using the :T10383/1 in direction of -arrow- by sliding the wedge approximately 2 mm in the seam under the speaker trim.

-- Disengage the remaining tabs for the speaker trim along the seam.

-- If necessary, insert a long screwdriver forward under the speaker trim and disengage the front retaining pin.

Outer Speaker Trim, Removing:

Fig 2: Outer Speaker Trim

CAUTION:

There is a risk of damaging the speaker trim.

Proceed very carefully when removing and installing.

-- Using the :T10383/1 , carefully detach the speaker trim -1- along the seam in direction of -arrow- by inserting the wedge approximately 2 mm into the seam under the speaker trim.

-- Release the remaining retainers for the speaker trim and remove it.

Installing

Install in reverse order of removal.