Front Pull Handle, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the door trim panel. Refer to FRONT DOOR TRIM PANEL, REMOVING AND INSTALLING .

-- Place the door trim panel on a soft surface.

-- Disconnect the connectors at the rear of the door trim panel.

-- Remove the bolts -arrows- .

-- Remove the pull handle with the armrest -1- from the door trim panel.

-- Release the retainers -1- using a small screwdriver. At the same time, unclip the switch mount -2- from the pull handle -3- using the :T10383/1 in direction of -arrow- .

-- Release the remaining retainers and remove the switch mount.