Plenum Chamber Side Cover, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04 and let dry.
-- Position the cover -2- using the clip on the body -1- -arrows- and press it on.
-- Remove the protective film from the adhesive tape -3- and press the cover onto the A-pillar.