High Pressure Sensor -G65-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Replace the O-ring seal -B-, and coat lightly with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
-- Tighten the High Pressure Sensor -G65- -A-.
Tightening specification:
- Refer to OVERVIEW - CONDENSER