Condenser, Removing And Installing, RS Models: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- For all the following work, close the open lines and connections with clean plugs from the Engine Bung Set :VAS6122 .
-- Switch off the ignition.
-- Remove the bumper cover bracket together with the impact member. Refer to OVERVIEW - LOCK CARRIER .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Release the catches -arrow- and remove the air duct -1 and 3-.
-- Disconnect the connector -1- for the High Pressure Sensor -G65-.
-- Remove the bolt -2-.
-- Release the left and right catches -arrows-, disengage and remove the condenser on the radiator.