Front A/C Display Control Head -E87-, Removing And Installing, Q5: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Secure the Front A/C Display Control Head -E87- -B- on the guides for the trim -D-.
-- Install the Front A/C Display Control Head -E87- -B- all the way in the trim -D- and the tabs -A- click into place.
-- Install the bolts -C-.
Reinstall in reverse order of removal. Note the following:
-- After installing the Front A/C Display Control Head -E87- check the DTC memory and if necessary erase. Use the Vehicle Diagnostic Tester.
-- If the Front A/C Display Control Head -E87- is replaced, complete the test plan using the Vehicle Diagnostic Tester.
Tightening Specification
| Component | Tightening Specification |
|---|---|
| Front A/C Display Control Head E87 on the trim | 1.5 Nm |