Right Temperature Control Door Motor -V159-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the right front seat all the way to the rear.
-- Switch off the ignition.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR DUCT FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Remove the right footwell vent. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Remove the Right Side Vent Motor :V300 . Refer to Right Side Vent Motor -V300-, REMOVING AND INSTALLING .
-- Label the connector -C- (to prevent a mix up if several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Disconnect the connector -C-.