Right Side Vent Motor -V300-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the right front seat all the way to the rear.

-- Switch off the ignition.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR DUCT FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .

-- Remove the right footwell vent. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Loosen the air duct above the central tube and push as far as possible to the outside. Remove the air duct for the instrument panel vent to do this. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR FRONT .

-- Label the connector -C- and the actuator -B- (to avoid a mix up in case several connectors are disconnected at the same time).

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -A-.

-- Remove the actuator -B- from the door shaft -D-.

-- Disconnect the connector -C-.