CLUTCH PLATE, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" (WITH A/C CLUTCH -N25-): Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

The thread of the new clutch plate has already been greased with a specific amount of a grease by the manufacturer.

-- Clean the contact surfaces on the clutch plate and belt pulley before attaching.

-- Clean the A/C compressor shaft threads before attaching the clutch plate.

-- After tightening, check the gap dimension between the belt pulley and clutch plate and correct it if necessary. Refer to GAP DIMENSION BETWEEN BELT AND CLUTCH PLATE, CHECKING, "Denso" A/C COMPRESSOR, WITH A/C Clutch -N25- .