Overview - Bumper Cover Mount
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Mount
- Side
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, SIDE .
- Bolt
- Tightening sequence. Refer to Fig 2.
- Quantity: 3
- Locking Mechanism
- For attaching the rear bumper cover to the upper mount
- Bolt
- A4 sedan, A5: quantity: 2
- Wagon, quantity 1
- Tightening sequence. Refer to Fig 3.
- Mount
- Upper
- For securing the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, TOP .
Bumper Cover Side Mount - Tightening Specification and Sequence
- Tighten the screws -1, 2 and 3- to 3 Nm.
Bumper Cover Upper Mount - Tightening Specification and Sequence
- A4 sedan, A5: tighten the bolts -1 and 2- to 3 Nm.
- Avant: tighten the bolt to 3 Nm.