Overview - Bumper Cover, RS4 From Product Improvement

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Front Bumper Cover (A5 Basic/Lines From Product Improvement)

Courtesy of AUDI OF AMERICA, LLC

Front Spoiler
- Removing and Installing. Refer to FRONT SPOILER, REMOVING AND INSTALLING, RS 4 AND A5 .
Bolt
- Tightening specification OVERVIEW - COVERS AND AIR GUIDES
Bolt
- Tightening specification OVERVIEW - COVERS AND AIR GUIDES
End Panel
- The bumper cover
- Overview. Refer to OVERVIEW - COVERS AND AIR GUIDES .
Trim Molding
- Center
- Removing and Installing. Refer to CENTER TRIM MOLDING, REMOVING AND INSTALLING .
Towing Eye Cover
Bumper Cover
- Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
- Adjusting. Refer to BUMPER COVER, ADJUSTING .
Radiator Grille
- Overview. Refer to OVERVIEW - RADIATOR GRILLE .
Lock Carrier Cover
- Overview. Refer to OVERVIEW - COVERS AND AIR GUIDES .
Air Intake Grille
- Center
- Removing and Installing. Refer to CENTER AIR INTAKE GRILLE, REMOVING AND INSTALLING, A5 BASIC/LINES FROM PRODUCT IMPROVEMENT .
Bolt
- 2 Nm
- Quantity: 7
Mount
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Bolt
- 4 Nm
Expanding Rivet
Nut
- 4 Nm
- Quantity: 2
Bolt
- 2 Nm
- Quantity: 2
Air Duct
- Side
- Removing and Installing. Refer to AIR GUIDE, REMOVING AND INSTALLING, A5, RS 4 AND RS 5 .
Expanding Rivet
Air Intake Grille
- Side
- Overview. Refer to OVERVIEW - COVERS AND AIR GUIDES .
Washer Nozzle Cover
- For the headlamp washer system
- Removing and Installing. Refer to HEADLAMP WASHER SYSTEM WASHER NOZZLE COVER, REMOVING AND INSTALLING .
Trim
- Only for equipment versions without Control Module for Adaptive Cruise Control -J428-
- Clipped in the bumper cover.