Molded Foam Part, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Vehicles equipped with pedestrian protection:
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Disconnect the connector -2- by removing the connector lock and pressing it down.
Continuation:
-- Release the tabs in direction of -arrows- and remove the molded foam part -1- from the impact member.