Molded Foam Part, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Engage the pedestrian protection crash sensor -1- into the molded foam part -3-.
CAUTION:
Risk of damaging the pressure hose by deforming it.
- Never kink or stretch the pressure hose.
-- Insert the pressure hose -2- into the recess in the molded foam part.
- The pressure hose must be inserted without any tension.
-- If equipped, insert the reinforcement -1- in the molded foam part -2-.
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place in direction of -arrow-.
-- Push in the connector lock -2- to secure the connector.