Impact Member Mount, Removal and Installation: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the connector -1- on the horn -2- and free up the wiring harness -3-.
-- Remove the screws -arrows-.
-- Remove the bolts -1 and 4-.
-- Pull the lock carrier -3- slightly forward, push the impact member mount -2- upward and out of the guide -5- in direction of -arrow- and remove it to the side.