Shock Absorber, Removing And Installing: Notes

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 1331 5-50Nm :VAG1331
Torque Wrench 1332 40-200Nm :VAG1332
Engine and Gearbox Jack :VAS6931
Engine/Gearbox Jack Adapter - Wheel Hub Support :T10149

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Mandatory Replacement Parts

Bolt - Shock Absorber Mount to Body
Bolt/Nut - Shock Absorber to Rear Lower Transverse Link

NOTE:

Because of different shock absorber valve systems, only install new shock absorbers from the same manufacturer on both axles, if possible.