Tie Rod, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the boot. Refer to BOOT, REMOVING AND INSTALLING .

-- Position the front wheels as follows:

For the left tie rod, turn the steering to the left until it stops
For the right tie rod, turn the steering to the right until it stops

-- Remove the spring clip with the :VAG1923 -2- by counterholding at the steering gear steering rack with an open end wrench -1-.

Fig 1: Removing Tie Rod

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of the steering gear being destroyed by moisture and dirt.

There must be a visible film of grease present on the steering rack near the splines. If the film of grease is missing, replace the steering gear.