Tie Rod End, Removing And Installing: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm :VAG1332
- Torque Wrench 1332 Insert - Ring Wrench - 21mm :VAG1332/7
- Engine and Gearbox Jack :VAS6931
- Ball Joint Splitter :VAS251805
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Spring Clamp - Boot to Tie Rod End