Active Steering Safety Lock (Locking Solenoid), Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Place the adjusting element according to the mark applied during removal and tighten (use the socket included in the repair kit). Refer to Figure.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Chassis
- Steering
- 0001 - OBD-capable system
- 001B - Active Steering Control Module - J792
- 001B - Active Steering Control Module, functions
- 001B - Basic setting
- 001B - Basic setting complete
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.