Bearing Inner Race Version 2

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Place Puller On Ball-Cage

Courtesy of AUDI OF AMERICA, LLC

-- Place the puller -1- on the groove -arrow- of the bearing inner race -2-.

Continuation for All Versions

Fig 2: Clamp The Puller On The Bearing Inner Race -2-

Courtesy of AUDI OF AMERICA, LLC

-- Clamp the puller on the bearing inner race -2- by turning the :VAS701003/7 with the :VAS701003/5 in the direction of -arrow- and counterhold the :VAS701003/1 with the :VAS70003/4 .

-- Remove the bearing inner race with the : VAS701003/2 from the wheel hub -1-.