Wheel Bearing Housing, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and Note The Following:

-- Slide the wheel bearing housing onto the drive axle splines.

-- Install the control arm. Refer to CONTROL ARM, REMOVING AND INSTALLING .

-- Install the upper control arm. Refer to UPPER CONTROL ARM, REMOVING AND INSTALLING .

-- Tighten the threaded connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .