Upper Control Arm, Removing And Installing: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Vehicle Diagnostic Tester
- Torque Wrench 1331 5-50 Nm:VAG1331
- Torque Wrench 1331 Insert - Ring Wrench - 16mm:VAG1331/12
- Torque Wrench 1332 40-200 Nm:VAG1332
- Engine and Gearbox Jack:VAS6931
- Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - for Upper Control Arm Bushing
- Bolt/Nut - Upper Control Arm Bushing to Wheel Bearing Housing