SUBFRAME, Lowering: Installing: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and Note The Following:
-- Remove the :T40327 . Refer to SUBFRAME, SECURING .
-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
NOTE:
Bonded rubber bushings have a limited range of rotation. Only tighten the threaded connections for the suspension when the vehicle is in curb weight position.
-- Lift the wheel bearing in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING
WARNING:
Risk of accident!
- If the vehicle will be driving on the streets, all bolts and nuts must be tightened properly according to the guidelines.
-- Connections and wire routing. Refer to the appropriate Wiring Diagram(s).