SUBFRAME CROSSBRACE, Removing And Installing: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm:VAG1331
- Engine and Gearbox Jack:VAS6931
- Rear Axle Support:T10552
- Puller - Ball Joint:T40043
- Strut:T40335
- Locating Pin:T40334
- Mount:T40386 , not illustrated
Tools, Preparing
-- Loosen the bolts -arrows-.
-- Adjust the dimension -a-.
- Dimension -a- = 250 mm
-- Tighten the bolts again.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe Crossbrace to Subframe
- Bolts - Subframe Crossbrace/Steering Gear to Subframe
- Bolt - Clip to Subframe Crossbrace