Drive Axle, Disassembling And Assembling, Triple Roller Joint AAR 2600 I And AAR 3300 I: Notes
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Press Plate:VW401
- Press Plate:VW402
- Press Piece - Rod:VW408A
- Press Piece - Rod:VW411
- Press Piece - 31.5mm:VW416B
- Press Piece - Multiple Use:VW447H
- Slide Hammer Set:VW771
- Clamping Pliers:VAG1682A with Clamping Pliers - Jaws:VAG1682A/1
- Tripod Joint Tool:T10065
- Assembly Tool:T10065/1
- Triple Roller Assembly Tool:T10065/5
- Triple Roller Assembly Tool:T10065/6
- Triple Roller Assembly Tool:T40018 for driveshafts with triple roller joint AAR 3300 i
- Triple Roller Assembly Tool:T40084 for driveshafts with triple roller joint AAR 2600 i
- Pneumatic Hydraulic Press:VAS6654
- Commercially available locking ring pliers.
NOTE:
The procedure for drive axles with triple roller joint AAR 2600 i and AAR 3300 i is the same, but with the following difference:
The :T40084 is used for the triple roller joint AAR 2600 i.
The :T40018 is used for the triple roller joint AAR 3300 i.