LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Turbocharger, Supercharger [CVKB,DBPA,CWNA,CVLA,DEMA,DHDA]) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, Removing And Installing >> Installing

Charge Air Pressure Sensor -G31-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2020 Audi A4, 2019 Audi A4, 2018 Audi A4, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and Note The Following: 

-- Bring the Charge Air Pressure Sensor -G31- into the installation position and turn clockwise until it engages.

NOTE:

Replace the O-ring after removing.

If the catch on the air duct pipe is broken secure the Charge Air Pressure Sensor -G31- with two bolts. Refer to Parts Information.

scientia non olet · About LEMON Manuals