Metal Valve Body, Removing And Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench :VAG1410

-- Place the metal valve with rubber seal through rim from inside.

-- Position the beveled washer and union nut from outside and tighten.

-- Secure against turning with counterholder -1- (for example, a 2 mm drill bit).

Fig 1: Securing Against Turning With Counter Hold

Courtesy of AUDI OF AMERICA, LLC

-- Push the tire pressure monitoring sensor -1- into the bed and tighten.

Fig 2: Pressing Wheel Electronics Into Bed

Courtesy of AUDI OF AMERICA, LLC

Tightening Specifications

Refer to OVERVIEW - TIRE PRESSURE MONITORING SENSOR