Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the parking brake.
-- Switch off the ignition.
-- Remove the rear wheel. Refer to Wheels and Tires .
-- Disconnect the connector -3- for the parking brake motor.
-- Open the clip -2- and free up the brake pad wear indicator sensor wire.
CAUTION:
Hold the parking brake motor securely when loosening the bolts -arrows-.
The motor can turn by itself on its input shaft when loosening the bolts -arrows-.
-- Remove the bolts -arrows-.
-- Remove the parking brake motor -1- from the brake caliper.
-- Remove the seal.