Brake Rotor, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Clean bolts before reusing
Replace the damaged bolts. Refer to the Parts Information.
Install in reverse order of removal and note the following:
-- Check the brake rotors for wear and damage before reusing them.
NOTE:
Always replace brake rotors on both sides of the axle.
Brake pads likewise must be replaced on both sides of the axle.
-- Thoroughly clean the brake rotor and hub contact surfaces and clear them of corrosion.
NOTE:
Greasing the contact surfaces of the brake rotor and the wheel hub is not permitted.
-- Do not tilt the brake rotor when mounting it on the wheel hub.
-- Tighten the bolt -arrow-.
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.