Brake Caliper, Removing And Installing, 1LC/1LD/1LE/1LF/1LH: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Clean bolts before reusing.
Replace the damaged bolts. Refer to the Parts Information.
-- Clean the brake caliper.
-- Carefully slide the brake caliper with the brake carrier and the installed brake pads over the brake rotor.
-- Tighten the brake caliper with bolts -1-.
WARNING:
After installing the brake caliper, check the clip and brake pads for correct seating.
NOTE:
Make sure the brake hose is routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
-- Insert the brake hose -1- in the bracket -2- and secure using the clamp.
-- Connect the connector -arrow- for the brake pad wear indicator sensor contact to the brake caliper.
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.