Mounting Bracket, Removing And Installing: Removing

-- Remove the instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

Fig 1: Identifying Driver Side Instrument Panel Cover With Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Disconnect the brake pedal from the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .

-- Remove the steering column. Refer to STEERING COLUMN, REMOVING AND INSTALLING .

-- Disconnect the connector -C- to the accelerator pedal module and free up the wire.

Fig 2: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Release the clutch master cylinder using the :3355  , and turn the tool clockwise -arrow-.

Fig 3: Releasing Clutch Master Cylinder

Courtesy of AUDI OF AMERICA, LLC

-- Remove the mounting pin for the clutch master cylinder -1-.

Fig 4: Identifying Mounting Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

Make sure that no brake lines are bent or damaged.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1- and bolt -2-.

-- Remove the mounting bracket from the vehicle.

-- Remove the brake pedal. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .

-- Remove the over-center spring -2-. Refer to the appropriate service information.

Fig 5: Actuating Clutch Pedal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clutch pedal. Refer to the appropriate service information.

-- Remove the accelerator pedal module. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79- / -G185-, REMOVING AND INSTALLING