Mounting Bracket, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Install the accelerator pedal module. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79- / -G185-, REMOVING AND INSTALLING

-- Install the clutch pedal. Refer to the appropriate service information.

-- Install the over-center spring -2-. Refer to the appropriate service information.

Fig 1: Actuating Clutch Pedal

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake pedal. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .

-- Insert the mounting bracket and bring into the installation position.

-- First insert the bolts -arrows- and tighten to 25 Nm.

Courtesy of AUDI OF AMERICA, LLC

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Tighten the mounting bracket to all of the required tightening specifications. Refer to OVERVIEW - BRAKE PEDAL .

-- Engage the clutch master cylinder in the mounting bracket using the :3355  .

Rotate the tool counter-clockwise in the direction of -arrow B- while pulling the master cylinder forward in the direction of -arrow A-.

Fig 2: Identifying Clutch Master Cylinder Into Footwell

Courtesy of AUDI OF AMERICA, LLC

-- Connect the clutch master cylinder to the clutch pedal.

-- Install the mounting pin for the clutch master cylinder -1-.

Fig 3: Identifying Mounting Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the steering column. Refer to STEERING COLUMN, REMOVING AND INSTALLING .

-- Connect the brake pedal to the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .

-- Install the footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

Fig 4: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Install the instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

Fig 5: Identifying Driver Side Instrument Panel Cover With Bolts

Courtesy of AUDI OF AMERICA, LLC