Vacuum Sensor -G608-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1- for the Vacuum Sensor -G608-.
-- Push the slider on the connector toward the rear to do this.
-- Release the catches in the direction of -arrows- and carefully remove the Vacuum Sensor -G608- -2-.