LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Hydraulic Components (Brake System) (2 Of 2)) >> 47 Hydraulic Components >> Vacuum System >> Vacuum Sensor -G608-, Removing And Installing >> Installing

Vacuum Sensor -G608-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the Vacuum Sensor -G608- in the retainer.

NOTE:

The Vacuum Sensor -G608- must be felt engaging in the retainer.

NOTE:

Make sure the vacuum hose is connected at all of the separating points.

-- Slide the connector on the Vacuum Sensor -G608-

-- Lock the connector for the Vacuum Sensor -G608-. Push the slider on the connector toward the front to do this.

NOTE:

The connector must be securely locked to the connection with the slider to prevent the connector from sliding out.

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals