Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. Refer to Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING ; Engine Temperature Control Actuator -N493-, Removing and Installing.

-- Remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Remove the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Lift the clamp -1 and 3-, and remove the coolant hoses.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- for the Engine Temperature Control Actuator -N493-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 to 5-.

Fig 1: Engine Temperature Control Actuator Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Take the Engine Temperature Control Actuator -N493- off the centering pins and remove it from the engine oil cooler.