Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

The engine is cold.

Depending on the model, preliminary work may be required. Refer to Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING .

-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- To reduce the residual pressure in the cooling system, briefly open the coolant expansion tank cap -1- by releasing the retainer in direction of -arrow- if necessary.

Fig 1: Coolant Expansion Tank

Courtesy of AUDI OF AMERICA, LLC

Tip:

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -1- on the Engine Coolant Temperature Sensor -G62-.

Fig 2: Identifying Engine Coolant Temperature Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Place a cloth underneath to catch any escaping coolant.

-- Remove the bolts -arrow- and remove the Engine Coolant Temperature Sensor -G62- -3-.

Replace the O-rings after removing them.

-- To prevent coolant loss, install the new coolant temperature sensor immediately.

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - ENGINE COOLANT TEMPERATURE SENSOR