Coolant Pump, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

Toothed Belt Guard, Version 1:

Fig 1: Oil Pressure Switch, Level 3 -F447- Installation Position -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Remove the bolts -arrows- and remove the toothed belt guard.

Toothed Belt Guard, Version 2:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Free up the wiring harness -3-.

-- Remove the bolts -arrows- and remove the toothed belt guard -1-.

Continuation:

Fig 2: Coolant Pump - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

-- Remove the toothed belt from the coolant pump.