Coolant Pump, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Used coolant cannot be used again.

-- Install the coolant pump -1- and toothed belt.

Fig 1: Identifying Controller Housing

Courtesy of AUDI OF AMERICA, LLC

-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.

Fig 2: Identifying Coolant Pump

Courtesy of AUDI OF AMERICA, LLC

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .